Step 1

Remove current grip tape and all residue.

Step 2

Apply 2-3 double sided pieces of tape to the shaft of the club. Make sure the tape is long enough for the entire length of the grip. Apply an additional strip, approximately an inch in width at the top of the shaft if needed.

Step 3

Make sure the hole on the bottom of the grip is plugged (we recommend a golf tee) and apply your solvent into the grip making sure the entire inside of the grip is lubricated.

Step 4

Remove the golf tee from the bottom of the grip above the shaft making sure the solvent is coating the double-sided tape.

Optional Step

To ensure that the top of the grip where the knob is located is held in place, apply a spray or two of adhesive into the grip. This will ensure the grip locks onto the tape.

Step 5

Slide the grip onto the shaft, ensuring that the line one the bottom of the grip is aligned with the face of the club.

Step 6

Once the grip is aligned with the face of the club, give the grip a few taps on the ground to ensure that the knob of the grip is all the way onto the club and is sticking to the tape at the end.

Step 7

Let the grip set overnight.

Step 8

Take it to the course and hit some bombs down the fairway!

Shop Bighead Now